Notices

my lude wont start!!!

Thread Tools
 
Old Aug 24, 2006 | 09:55 AM
  #21  
stereo's Avatar
stereo
Senior Member
 
Joined: Jul 2004
Posts: 901
Likes: 1
From: CA
Default

have you checked the timing belt ? main relays usally will start fine when cold but not if it's not outside or after the engine is running.
Reply
Old Aug 24, 2006 | 10:48 AM
  #22  
VPUPPY's Avatar
VPUPPY
Senior Member
 
Joined: Nov 2002
Posts: 1,975
Likes: 0
From: Orlando, FL
Default

Originally Posted by Protected-Above
Friend - we are in the same boat damnitt!! My 91 lude does the same thing, I replaced the wires, rotor, and cap. Now as far as fuel goes; just loosen the banjo bolt a 1/4 turn on the fule rail and turn her over - if you have fuel pressure you will know it with a small mess. I have pressure.
My problem is I got 12 volts up to the cap, but not going out through the wires, I am about to take that back and get a new one?
Does your ECU flash any codes - its under the passenger side rug where the feet go.

write back if you found your problem
You need to check the ignition coil and ignition control module. I had a coil one burn out on a 98 civic right after replacing the cap, rotor, and wires. It ran for 2 mins then the car died and would not start. Check the coil for burn marks on its casing. You need to get you hands on a multimeter and test the coil for the resistance on the primary and secondary coil. If that checks out, then test the ICM.
Reply
Old Aug 24, 2006 | 02:00 PM
  #23  
Intege_92's Avatar
Intege_92
BAD ASS TEXAS BOY
 
Joined: Aug 2006
Posts: 16
Likes: 0
From: TEXAS
Default

Dont Forget 2 Check Ur Ecu Thats What Happened 2 Me My Car Would Crank But It Wouldnt Start Like I Wasnt Getting Any Fuel Well Anyways My Distributor Went Out And My Ecu Since U Replaced The Distributor Check The Ecu The Way U Can Test It Is Test It On Someone Elses Car Hope This Helps !!!!
Reply




All times are GMT -8. The time now is 10:42 PM.