Shmoo's GSR Engine Build: Operation 400whp not 56k friendly
Thread Starter
On permanent hiatus
Joined: Jul 2004
Posts: 9,716
Likes: 0
From: A forum with actual tech
Yeah, for now. If I can't stand it, it will be easy to reroute it into the downpipe.
Thread Starter
On permanent hiatus
Joined: Jul 2004
Posts: 9,716
Likes: 0
From: A forum with actual tech
Mike at SLS is a good guy and I am sure he will make this correct without any hassle. I would have confirmed every step of the way what engine this was for since it was overlooked by two people before I received it.
Your setup is looking sick!...
Regarding your bottom-end, is there anything needed to do to the crankshaft to widthstand the added power? Also, will you be putting the rotating assembly in or will a shop do this for you?
Regarding your bottom-end, is there anything needed to do to the crankshaft to widthstand the added power? Also, will you be putting the rotating assembly in or will a shop do this for you?
Thread Starter
On permanent hiatus
Joined: Jul 2004
Posts: 9,716
Likes: 0
From: A forum with actual tech
I will be putting it all in myself. The machine shop is only going to bore and hone the block for me. Selecting bearing sizes, measuring clearances, and assembly is all going to be done by your's truely.
I talked to Mike at SLS today and he is fabbing me up a downpipe for the correct manifold as we speak, so I should have a new manifold in my hands at the beginning of next week. :yay:
Thread Starter
On permanent hiatus
Joined: Jul 2004
Posts: 9,716
Likes: 0
From: A forum with actual tech
Watch this recent video of his car:
http://videos.streetfire.net/video/0...9901375609.htm
__________________
99 Integra GSR
06 TSX
duck squad member #00003
99 Integra GSR
06 TSX
duck squad member #00003


