idle problem
#11
internet hax0r elite
Join Date: Mar 2007
Location: satx
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
#12
internet hax0r elite
Join Date: Mar 2007
Location: satx
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
well at least it did till i sold it. no clue what its doing now
#13
Member
Thread Starter
Join Date: Jan 2007
Location: Lawrence,Mass 01843
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
i cleaned out the iacv and idle still bounces...i found a vacuum and it still bounces so my boy told me to take the intake off ands plug the top hole on the throttle with my finger and then the car runs fine. so i geuss i have to bypass the cold start. what do u think???
#15
Member
Thread Starter
Join Date: Jan 2007
Location: Lawrence,Mass 01843
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
well there is a ivac on the front of manifold... i pulled mine out and cleaned it with some carb cleaner and it running alot better... and i cleaned the throttle body..... i also bypassed the cold start..which is take the hoses off the ivac both under the throttle body and the one on the manifold. simple i just ran the hose from the block back to the block..any qeustions just ask
#17
Member
Thread Starter
Join Date: Jan 2007
Location: Lawrence,Mass 01843
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
it's real simple to do......... first make sure your antifreeze isn't hot.... alright there is two hoses going to the bottom piece attached to the throttle body.. i believe it's ur ivac.....there is also anothere i vac i think is is anyway but it's on the front of the manifold...it's held on by two bolts.. simple get rid of the hoses....(should also clean these parts with some carb cleaner.while u have them off).....basically check to see how the hoses run.... after that find where it comes from on the block and also where it goes back to the block...once u find that all u have to do is take one of the hoses u just took off and find one long enough to run from block to block...i would keep all the stuff u took off for winter time to reverrse the process.. any more qeustions feel free to ask
#18
Member
Thread Starter
Join Date: Jan 2007
Location: Lawrence,Mass 01843
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
check this forum out this guy tells alot about the h22
http://www.attackforums.com/showthread.php?t=1197
http://www.attackforums.com/showthread.php?t=1197
#19
internet hax0r elite
Join Date: Mar 2007
Location: satx
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
ghey theres a link on those forums to another one that has the information i need and its a pay site. GHEY!
on a side note, i think i located those 2 hoses. i think one of them can fit the entire length like you said. ill give it a shot
on a side note, i think i located those 2 hoses. i think one of them can fit the entire length like you said. ill give it a shot