heating problem
03-22-2006, 05:12 PM
#1
Junior Member
Thread Starter
Join Date: Jan 2006
Location: houston
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
heating problem
The question is my temp goes up when in traffic. When I go it starts going down a litle or when I turn the ac on low it seems to help. So when i got home I let it sit for awhile. Then check the fluid it's just fine then started the car and just let it run. It got hot after about five min. It got up to about half way. so I turned on my a/c itr made both fans come on so I checked the fuses for the cooling fan and relay there fine. Has any one else had this problem ? And how do you fix it?
03-22-2006, 06:46 PM
#2
Rachel Bilson
Join Date: Oct 2005
Location: South Bend/Walkerton, Ind
Posts: 11,230
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by christheape
The question is my temp goes up when in traffic. When I go it starts going down a litle or when I turn the ac on low it seems to help. So when i got home I let it sit for awhile. Then check the fluid it's just fine then started the car and just let it run. It got hot after about five min. It got up to about half way. so I turned on my a/c itr made both fans come on so I checked the fuses for the cooling fan and relay there fine. Has any one else had this problem ? And how do you fix it?
03-23-2006, 10:17 AM
#7
Senior Member
Join Date: Jun 2005
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
depends what kind car you have. the wire that goes to the primary fans is under the intake manifold. it's hooked up on the block, you can also by pass that and have it turn on when the ignition is on. that's what I did to mind becuase my switch sensor is bad. 89 crx
03-23-2006, 04:42 PM
#8
Junior Member
Thread Starter
Join Date: Jan 2006
Location: houston
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
well how do i do that ,or can iI just splice a switch in where the swensor is in the block Or tap in to the wires at the fan?
Last edited by christheape; 03-23-2006 at 04:47 PM.