Honda-Acura.net

Honda-Acura.net (https://www.honda-acura.net/forums/index.php)
-   Integra & 97-01 Integra Type-R (https://www.honda-acura.net/forums/integra-and-97-01-integra-type-r-17/)
-   -   heating problem (https://www.honda-acura.net/forums/integra-and-97-01-integra-type-r/229401-heating-problem.html)

christheape 03-22-2006 05:12 PM

heating problem
 
The question is my temp goes up when in traffic. When I go it starts going down a litle or when I turn the ac on low it seems to help. So when i got home I let it sit for awhile. Then check the fluid it's just fine then started the car and just let it run. It got hot after about five min. It got up to about half way. so I turned on my a/c itr made both fans come on so I checked the fuses for the cooling fan and relay there fine. Has any one else had this problem ? And how do you fix it?

F22B Prelude 03-22-2006 06:46 PM


Originally Posted by christheape
The question is my temp goes up when in traffic. When I go it starts going down a litle or when I turn the ac on low it seems to help. So when i got home I let it sit for awhile. Then check the fluid it's just fine then started the car and just let it run. It got hot after about five min. It got up to about half way. so I turned on my a/c itr made both fans come on so I checked the fuses for the cooling fan and relay there fine. Has any one else had this problem ? And how do you fix it?

AC wont make it cool down...turn on the HEAT..if it blows cold air than you prolly need a new thermostat.

christheape 03-22-2006 07:25 PM

when you turn the ac on it turns both fans on

christheape 03-22-2006 07:26 PM

so i need to figer out how & why my single fan isnt turning on when it gets hot

flybye 03-23-2006 07:29 AM

could be a fan switch.

R_Squared 03-23-2006 10:01 AM


Originally Posted by flybye
could be a fan switch.

where is that btw? I need to check mine out since my fans aren't kicking on.

crzy000 03-23-2006 10:17 AM

depends what kind car you have. the wire that goes to the primary fans is under the intake manifold. it's hooked up on the block, you can also by pass that and have it turn on when the ignition is on. that's what I did to mind becuase my switch sensor is bad. 89 crx

christheape 03-23-2006 04:42 PM

well how do i do that ,or can iI just splice a switch in where the swensor is in the block Or tap in to the wires at the fan?


All times are GMT -8. The time now is 09:46 PM.


© 2024 MH Sub I, LLC dba Internet Brands