Stupid car...Radiator's busted
Registered User
Joined: Apr 2004
Posts: 21
Likes: 0
From: Montreal, Canada
There's a much cheeper way. You can apply a product with flame heat that will act as a plastic weld. It goes for about 10$. I had my radiator go as well from the top (94 integra) and repaired it myself. It lasted an additional 4 years.
Be good
Joined: Feb 2004
Posts: 18,842
Likes: 0
From: Sloppy onshore junk.
I would use JB Weld man. Ive used that on all parts of my radiator on my prerunner. (see pic)
Ive also used it to permanently seal my visor onto my motocross helmet since the screw stripped and broke on it.
Ive also used it to permanently seal my visor onto my motocross helmet since the screw stripped and broke on it.
Last edited by CRAIGHIMSELF; May 16, 2007 at 11:56 AM.
Honda tech/eprom hackr
Joined: Oct 2002
Posts: 1,156
Likes: 0
From: Sacramento, CA.
Acura also lists just the tanks too in the parts catolag. I would just pull out the rad. and buy the top tank froom acura and have a rad shop replace and crimp it. I did my girlfrind 93 accord for 100 bucks and still had an oem rad.
Thread Starter
dc4 ownerages
Joined: May 2003
Posts: 645
Likes: 0
From: houston
well, i just spent 100 bucks on a 2001 integra oem radiator. its even jdm, y0! 
h: it cools probably 20% better than my other one, and is lighter. i dunno if i should take the top paint off, its type arrr yellow! :chuckles:
h: it cools probably 20% better than my other one, and is lighter. i dunno if i should take the top paint off, its type arrr yellow! :chuckles:
Thread
Thread Starter
Forum
Replies
Last Post
crxforum
Showroom
13
Apr 1, 2004 04:16 PM
