I'm not entirely sure what it is from reading their site... is it a chassis-stiffening brace?

 

thanks! :twisted:

 

Kabob, the way this works is there is a bar attached to where your stock tow hooks were. From this bar, there is a strut rod that is adjustable that attaches to each lower radius arm. By doing this it keeps your radius arms from going back and forth (wheel hop). You can adjust the preload on the strut rods by turning them, and then locking in place. Look under the Forced Induction Forum, under 3" downpipe thread, there is a picture of my car with the Z10 installed.

 

Now that brings up a question that's more important to me (since I don't drag race that often): Does the Z10 reduce handling since it seems to reduce/eliminate independent movement of the front wheels? Bear in mind that I road race/AutoX my ITR primarily.

 

They say it's good for both drag and road racing on their site, but I guess you'll never know till you try it.

Later,
Aj