Here you go.


I had to cut that edge so it would mount flush against the subframe. The inside piece also has that angled cut, but it comes that way.

Hope it makes sense.

 

get some bigger washers on there poindexter. look like the bolts are holding the bar on, by the edges.


I got one of the first beaks kit (which is now the one pictured) when it was released. Great piece. Loved mine.

I actually started a huge fight/debate about BSQ vs Beaks on here a while ago.

Get the beaks, it's a great piece, and Will is a great person to deal with.

 

I used BSQ's (that's the cheap one right?) specs and had my own made out of hardened steel.

I had absolutely no tearing problems.

 

I like living on the edge. :db:

I actually didn't even notice that till now. I'll be getting some washers ASAP. Thanks for pointing it out.

 

So after i install the ITR sway bar should i go get an aglignment done, or is not nessesary?

 

the bar should have no effect on your alignment

 

no need. it doesn't affect alignment.