b00gers

im one step from finishing the install. just 2 more bolts to tighten. but in the mean time i wrote a how to on how to do it. i know that bret (BSQ) already has a sufficient one, but i needed stuff for my site. check it out and give me feedback. and if you have installed the bar before, can you critque it for me? thanks a lot!

http://ownerages.com/itrinstall.htm

and my site... www.ownerages.com

AP2

Good how-to page. If there's a need I'll archive it.

RpG~^_^~LauRnO

i did it myself.. took me about 1.5 hours to do
good upgrad for non-ITR tegs

NOPD

where u get it, sounds good for my hatch

b00gers

thanks...

everything was bought from http://www.acuraautomotiveparts.net/

and the reinforcement kit from Bret (BSQ).

DVPGSR

How much of a difference is this from a GSR sway bar? Nice install instructions with Pics!

b00gers

i think the GSR has the same size as the LS....dont quote me though.

i cant wait to head up to the curvey roads around here....till then, im just swinging it around the corners.

BonzoAPD

nice site Will. How does it handle now? Is it worth doing that to my GSR or is there little difference in the GSR sway bar?

reno96teg

GS-R rear sway bar is 14mm, whereas the ITR rear sway bar is 22mm. it's worth it..

b00gers

i didnt get a chance to really make use of it. but you can really tell the rear end is tighter and feels like there is less roll. for about $100 and a few hours install time...go for it.