Yea, can you put a B16A or B18C1 head on a jap spec ZC motor? The ZC is dohc vtec, so how close are the heads?

 

Are you sure the ZC is vtec? I don;t think it is. Why would you want to put a b16A head on a ZC?

 

NO

 

yer right, the zc isnt vtec... Thought it was :dunno: But why couldnt you put a B16A or gsr head on it? They are both dohc, is the bolt patern diff or somn dubb?

 

Also, can you guys give me (to your best knowledge) all the performance parts available for the ZC motor? thanks.

 

Another question, does the ZC mate with any D series trany?

 

Yes the ZC does mate with the D-series but you have to switch the clutch. I had a crx with an Si tranny. Rocket! 70 mph in second gear at 7000 rpm.

 

Sounds good to me! Whats up with that clutch? And who makes cams for it?

 

The output shaft on the ZC is different then the SOHC output shaft. You need an ZC clutch or Si. As for cams ????

 

So what transmition did you use to hit 70MPH in second? was that the A6 or Y8 trany? I can use an SI clutch? off a B16A or a D16A6? I know they make cams for these cars I met a guy who had them.... Might have been web cams... I think.

I currently have a D16A6 with an act clutch so if its the D16A6 SI you speak of Im stoked!!! ZC + SI trany + act clutch