Notices
Engine Swaps, Tech & Tuning Swaps, N/A Performance, Forced Induction, Engine Management, & Troubleshooting

Need Help Troubleshooting? Engine rattle.

Thread Tools
 
Old Dec 10, 2002 | 01:23 PM
  #1  
00BLKV6CPE's Avatar
00BLKV6CPE
Thread Starter
Junior Member
 
Joined: Dec 2002
Posts: 2
Likes: 0
Default Need Help Troubleshooting? Engine rattle.

I have a '95 Civic EX (1.5L) and it is making a noise that sounds like a bearing rattle in the motor. It gets louder with the RPMs but is not present at idle. It kind of sounds like a marble knocking around. No loss of power and otherwise runs great.

Could it be anything with the alternator, AC, or timing belt area. It has 96,000mi. I'm being hopeful.

Any ideas of what to look for would be appreciated very much. I am mechanically inclined but have not done much on Hondas (they never break )

Thanks in advance!!
Reply
Old Dec 10, 2002 | 03:00 PM
  #2  
1stGenCRXer's Avatar
1stGenCRXer
GWAKS- Tech Geekifier
 
Joined: Oct 2000
Posts: 2,109
Likes: 0
From: Hampton, VA
Default

Sounds like a loose timing belt and/or valve out of adjustment.
__________________
-Harry
AIM: NDcissive
CRX and Pre '92 Civic, Engine Tech and Tuning, & Track and Autocross Forum Mod
Reply
Old Dec 13, 2002 | 06:45 AM
  #3  
00BLKV6CPE's Avatar
00BLKV6CPE
Thread Starter
Junior Member
 
Joined: Dec 2002
Posts: 2
Likes: 0
Default

Could I do the timing belt at home or are special tools required? Two different people have mentioned to check the water pump. I've never heard of a water pump making this type of noise but I'll listen to any suggestions. Thanks for your reply!
Reply
Old Dec 13, 2002 | 08:09 AM
  #4  
inspyral's Avatar
inspyral
のんびり~(´ε`)
 
Joined: Sep 2000
Posts: 2,314
Likes: 1
From: San Jo, Cali
Default

Originally posted by 00BLKV6CPE
Could I do the timing belt at home or are special tools required? Two different people have mentioned to check the water pump. I've never heard of a water pump making this type of noise but I'll listen to any suggestions. Thanks for your reply!
You'd have to be able to take the crank pulley bolt off, and most people usually have trouble with that. Beyond that, you would need a jack, jackstands, a socket set, and basic hand tools.
Reply
Old Dec 13, 2002 | 08:45 AM
  #5  
cvc2k's Avatar
cvc2k
Member
 
Joined: Oct 2002
Posts: 74
Likes: 0
From: Raleigh, NC
Default

and timing gun :-)
Reply




All times are GMT -8. The time now is 01:56 AM.