This is my new project and I want to make sure I have EVERYTHING I need before I start the swap. This is goin to be my 8th swap but unfortunatly I have only done swaps that "bolt directly in" they have all also been obd1 swaps. I am goin to get an obd2 swap to make it a little easier on me. Anyone have some pointers or even a page or two I can read up on before I start. I want to know everything, that could go wrong. Any suggestions is greatly appriciated. Thank you guys.

 

www.hybrid.honda-perf.org

 

Use your stock wiring harness and just add/change plugs. Be sure to get the 99 Si driver's upper and rear tranny brackets.

 

Thanks you guys have been a big help!