well let me ask you this, does your acceleration above 6k drop signifigantly?

i seriously doubt that you could get above 7k on the lower cams without being like "come on.. come on!"

also is there a CEL? (check engine light)

 

Ok, just went and tested it.

Acceleration above 6K is horrible. It does drop, so therefore, i guess the higher cams aren't kicking in at all. I have no CEL's what-so-ever

 

sounds like something went wrong.

have you done anything to it recently, you siad you installed ctr cams?

 

ctr cams installed on swap. vtec worked great for about 3 months. then today, it engaged late that one time, then next time not at all. any suggestions on what to do. i just rechecked the vtec connectors/solenoid and it is very nice and clean.

 

i was planning on boosting within the next month or so. no other mods accept a new intake within the past 3 months. i don't think the injen intake would have anything to do with it.

 

well you should be throwing a cel maybe theres something wrong with the vtec pins moving into position or with the pins themselves... thats honestly the best idea i can come up with but i've never taken apart the system peice by peice or installed one. i just know the theoretical ideas behind it.

 

damn..... i don't even know where to start. anybody else ?

 

post suttin in the engine tech and tuning board they should be able to help you out

 

i should probably run 12v to the vtec solenoid to see if it even engages.....only problem is, how do you do this ??? help

 

i'd connect it to the battery? but i'm not sure about any of the repurcutions