:werd:

or a heat gun.

heat gun takes longer but you wont burn ish under your car :devil:

 

----><----

 

speaking from experience rick?

 

woah ... never seen that before. i was wondering what PB was. where can i get the good stuff? just about anywhere?

 

You should be able to get it just about anywhere, swing by NAPA or something :dunno:?

 

PB Blaster is the best stuff for spraying on rusted a bolts. What I do is spray the PB all over the bolt let it sink in some. Than I use a MAPP Gas torch (with propane you will be sitting there all day waiting for it to heat up) and heat the bolt up sometimes until it is red hot. Than spray it again with PB which will cause it to cool very fast and hopefully sort of loosen. Than use your socket wrench on it. If not get one of these...

 

ooooooh ... i always wanted a heat gun. how much do they run?

 

:devil: maybe


but yep

I'd say 10minutes with a heatgun = 40minute of banging on a 4 year old rear rotor on a certain BMW 323i


:chuckles:

 

30-100. depending on type.

if it's cheaper it usually means it's not as strong so you just need to keep it on the nut or rotor for a longer time.

 

http://www.kanolabs.com/

Aerokroil is the best stuff... ever. Makes PB Blaster look like WD40.


Also, there's always your friendly Craftsman nut buster.