Oh okay, I didn't get what you were asking I guess. I'll see what they have available when I'm at work. I bet I can find quite a bit.

I will post your TSB tomorrow Binzo. Thanks for doing the research

jon...I have no idea, I kind of doubt it. Post it in the forum.

 

Can someone send me the information for TSB #01162005 sequence #10014750 titled REPLACEMENT OR UPDATED NAVIGATION DVD DISCS. It's for a 2005 Honda Accord EX navi sedan. The date of the TSB is 1/16/2005.

James

 

I already helped you, the TSB for P1457 was posted on the first page. I cannot help those who are unable or unwilling to do the legwork and help themselves first. kthxbye.

shonnv: I looked and couldn't find much on the navi...do you need wiring diagrams or what?

 

I have no idea what kind of car and what year it is. Please post year, make and model next time - once again, I can't search TSB numbers.

 

Where did you find this out I don't see a TSB like that anywhere.

 

Am having difficulty getting my back tail light cover off-- have removed nuts from inside and screw from the underneath, plus tried loosening the bolt plate (?) underneath but cannot get the cover to come out. Any suggestions as to what to do next? Would appreciate any help . Thanks.

 

Taillight Replacement

Taillight (4-door)

Remove the rear bumper.
Open the trunk lid and remove the trunk side trim panel.
Disconnect the connectors (A) from the taillight (B).
Remove the mounting nuts and screws, then remove the taillight.
Turn the bulb socket 45 °counterclockwise to remove the bulb.
Inspect the gasket; replace it. If it is distorted or stays compressed.
Install the taillight and tighten the nuts to 5 N.m (0.5 kgf.m, 4 lbf.ft) .
After installing the taillight, run water over it to make sure it does not leak.

Taillight (2-door)

Remove the rear bumper.
Open the trunk lid and remove the trunk side trim panel.
Disconnect the connectors (A) from the taillight (B).
Remove the mounting nuts and screws, then remove the taillight.
Turn the bulb socket 45 °counterclockwise to remove the bulb.
Inspect the gasket; replace it. If it is distorted or stays compressed.
Install the taillight and tighten the nuts to 5 N.m (0.5 kgf.m, 4 lbf.ft) .
After installing the taillight, run water over it to make sure it does not leak.

Inner Taillight (4-door)


Open the trunk lid and disconnect the connectors (A) from the trunk lid.
Remove the three nuts and the inner taillight (B).
Turn the bulb socket 45 °counterclockwise to remove the bulb.
Inspect the gasket; replace it. If it is distorted or stays compressed.
Install the taillight and tighten the nuts to 5 N.m (0.5 kgf.m, 4 lbf.ft .
After installing the taillight, run water over it to make sure it does not leak.

 

98CoupeV6
I found the TSB on Edmunds.com and the nhtsa.dot.gov site.

 

I don't have it, sorry. That TSB number isn't a Honda number even, it's just the date, so I don't know where it could be.

 

I am trying to find a wiring diagram on my VSS.
Or diagram on my cluster. I have a Accord 05 6cyl. with nav.