I remember seeing an article on this at honda-prelude.com before it closed down. There was a way you could clear the yellow out of the 4th gen tail light. Also you could wire the turn signal so that it would fill the entire bottom part of the turn signal instead of just the little square. Anyone know what I'm talking about? Or have the article? Any help would be greatly appreciated and thanks in advance

 

I've seen it done. I know you have to put them in the oven (I think 225 degrees) to get the glue soft then they will come apart. You have to find a clear piece of reflector and cut it to fit the old space. To get the turn signal to fill up the whole bottom section you can try just putting the bulb in the middle or else you would have to splice another wire and bulb in.

 

go to http://www.ntpog.org/

a list of free mods and all sorts of stuff

 

That's a great site... I've gone there many times for some mod reading and such. I wish there was a group like that around here.

 

my bf did a great write up with pictures.. here you go....

http://www.lasalle.edu/~garofom1/wri...hgentails.html