I have a 1998 Honda Prelude Type Sh. I'm pulling my motor but I cannot get my left drive shaft out of the atts unit. I dont want to pry it out or anything until I know if there is any sort of pin or clip holding it in. Most hondas that I have delt with, gsrs and rexs, just slip out but I dont know if the ATTS changes something or not. Could someone please fill in some info for me. Thanks in advanced.

 

Noones ever replaced or even removed a cvc shaft?

 

are you talking about the intermediate shaft or the axle?

i believe there's a bracket holding the intermediate shaft to the block, but i've never seen it myself since i've got a base.

 

Its the actual drive shaft. On the right it just comes out of the tranny and goes straight to the wheel hub. On the left side coming out of the tranny theres about 2 inches of a shaft showing, then it goes into to big square casings which I assume is the atts unit cause no other Honda Ive worked on has had it. Then after the ATTS unit theres about a 2 foot peice going to the left wheel hub. We cant get it out of where it meets the ATTS unit.