95 GSR part out. 5 lug, built motor, LSD, turbo kit, JDM front end, Recaros, rolling
Thread Starter
Registered User
Joined: Sep 2004
Posts: 82
Likes: 0
From: Sudbury, MA
The wing is a fiberglass replica, but fits like oem. For the front end I'm asking $1200. That gets you the headlights, radiator support, oem metal hood, fiberglass bumper, and grill. The fenders are molded to the car, but I could cut them off if you want those too.
Thread Starter
Registered User
Joined: Sep 2004
Posts: 82
Likes: 0
From: Sudbury, MA
Thread Starter
Registered User
Joined: Sep 2004
Posts: 82
Likes: 0
From: Sudbury, MA
Thread Starter
Registered User
Joined: Sep 2004
Posts: 82
Likes: 0
From: Sudbury, MA
Here are the specs on the Built motor: Block bored to 82mm, honed, decked, hot tanked, head planed and hot tanked, ported exhaust side, crank cleaned, JE 82mm 9:1 pistons, eagle H-beam rods, ARP rod bolts, ACL bearings, ARP head studs, golden eagle 82mm head gasket, P72 head with new valve seals, GSR valves, springs and retainers, P72 vtec solenoid, type R valve cover, adjustable cam gears, obd2 lower timing belt cover, type R oil pump, z10 plug for catch can, New OEM: timing belt, tensioner, water pump, gaskets, seals and bolts, water pipe, sensors, thermostat, thermostat housing. The pan has been tapped for the oil return line.
Junior Member
Joined: Jan 2007
Posts: 2
Likes: 0
bout the type r
hey wats up.. i saw that u were from sudbury mass.. neways im from mass as well.. i was curious to see if u still had the the 5 lug conversion?? and if soo , if possible for me to come look at this week.. well please write me back to geovannie_017@hotmail.com or call me 617438-8311.thanks alot...alex......
