this is wat i have left

1. complete b18a disasembles motor w/ 17k on it. the block has been hot tanked and honed, the head has been hot tanked and comes with new valve guides.all bolt and nuts are organized and in marked zip lock baggys. it also come with wiring and ecu---sold

2.nib os ctr pistons and rings-150

3.two gas tank lids for civic or crx-5 ea.

4.three rearview mirror-5 ea.

5.two mirror for civic or crx-15 ea.

6.crx speedo bezal-10

7.crx ash tray-3

8.d16z6 motor and tranny-75---sold

9.ys1 tranny-50

10.pm5 ecu-15

11.pm6 ecu-15

12. three crx or civic handle (left and right)-5 ea.

13.crx streering wheel-15

14.crx e-brake cover-5


i have pics of everything
many more parts coming soon!!!!

thanks,
clay

 

up top

 

bump

 

day bump

 

morning bump

 

bump

 

so the pistons are oversized to fit a stock bore b18a? i have mine bored a little over.

 

they are .25 over.
if you had yours is bored thats prolly wat they bored it to, its hard to go any smaller. you should call your machine shop and make sure they bored it and not honed it.

 

well there was some surface rust on the inside of the cylinder walls. and i brought it to be honed to fix that. they said that in order for the block to function, i need to have it bored, becuz the rust in two cylinder walls went a little too deep. what size would it need to be bored to for these pistons to work? i'll call them tomorrow and check to see what they did exactly. i might have the paperwork. this engine is one of my last projects ahead of me so i havent been paying too much attention to it unfortunately. so excuse my ignorance.

 

it needs to .25 over the stock 84mm