Just thought i'd share something...
#1
Senior Member
Thread Starter
Join Date: Jul 2005
Location: Delaware, Ohio
Posts: 1,219
Likes: 0
Received 0 Likes
on
0 Posts
Just thought i'd share something...
hey ya'll. i have a project i'm going to start here in a short while, and wanted to share it w/ you guys. basically, i'm building a cart. however, i'm using all the operating systems of either a CBR600 F4, or a GSXR 750. it's going to use 4 corner discs, that i got off of two '01 929s. for susupension, it'll be fully independant front and rear, using 1 600 F4i rear shock on each corner. full tube chassis (between 300 and 500 lbs). custom shift setup (using a series of 1/4" bars and joints)... still 1 down and 5 up like on the bike. all of the engine management, exhaust, and braking will be similar to the stuff off the bikes. pedal brake, pedal throttle, and pedal clutch. rear chain drive... mid-mounted engine. all the lights/signals will be there, w/ controls mounted on a cross bar next to the seat. and to top it off... a 3-4 gallon fuel cell. it should be fast as hell, 11s @ the least is my guess. what do ya'll think?
#3
You must not have seen the Monster Garage where they were building a cart with a Hayabusa motor. It was a failure and Jesse blew it up at the end. Maybe it was because they had a time limit or something, but maybe you'll have better luck.
#4
Senior Member
Thread Starter
Join Date: Jul 2005
Location: Delaware, Ohio
Posts: 1,219
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Tankard
You must not have seen the Monster Garage where they were building a cart with a Hayabusa motor. It was a failure and Jesse blew it up at the end. Maybe it was because they had a time limit or something, but maybe you'll have better luck.
#6