I just changed out engine and transmission in a 1991 acura integra. We went from an automatic to a manual trans. Now engine will turn over but there is no spark. Any suggestions as to why? Cant seem to figure out the problem

 

Did you use a know good distributor? Do you have another distributor laying around? It is a simple system the ecu sends a signal to the igniter the igniter controls the coil, coil fires the plugs.

Is your cel doing it 2 sec bulb test?

If you need a wire diagram go to www.hondatech.info and search for your car.

 

Did you swap the ecu for a manual one also?