Does anyone make a valve cover for an LS? I haven't seen any around. Mine is pretty dingy although I may be swapping out with a friend soon.

I would have searched for this but you can't type in words such as LS since it is under the minimum word length.

 

moroso makes a hideous valve cover for the LS. why not just strip off the wrinkle paint and powdercoat it? :dunno:

 

that's what I'm going to have to do I guess. don't you have to get it sandblasted?

 

sandblasting will be easier than using sandpaper. If you sandblast just go over it with a fine-grit paper then.

 

the paint is coming off my dohc vtec cover......... didn't think that was supposed to happen :dunno:

 

it happens, often - my GSR's is coming off around the oil cap and on the right of the "DOHC VTEC" lettering.

 

Tenzo makes valve covers for D series and B sereis VTEC, they may be makeing them for non-VTEC Bs now.

 

if you dont want down time, i have a spare b18a valve cover i could sell you... and i know somebody with a b18b valve cover for sale... not sure if they are interchangable... :dunno:

 

Use Aircraft Coating Remover to take the high temp paint off. It costs $5 from the car parts store. :thumbup:

 

Right, no need to sand. Sanding will screw your valve cover up royally. Also, no need to get it powder-coated, you can paint it yourself with some high quality paint. Check the articles section over at www.team-integra.net , there's a good article with instructions and examples.