Question about shift linkage
Thread Starter
Junior Member
Joined: Oct 2002
Posts: 5
Likes: 0
Question about shift linkage
I am working on a 1990 acura integra 5 sp. I cant see how to get the shift linkage off of the transmission. It looks like there should be a bolt through it but it isnt a bolt. It almost looks like pins. Whats the deal? Thanks
Senior Member
Joined: Mar 2002
Posts: 356
Likes: 0
If i remember correctly, there's a rubber boot over the part closest to the tranny. You have to slide that rubber boot back and that will reveal the pin you have to knock out. After you get the pin out it should separate just fine.
Member
Joined: Aug 2002
Posts: 76
Likes: 0
From: tx
yep that's right.
http://www.c-speedracing.com/howto/b18cswap/swap.html
The Internet is your friend.
http://www.c-speedracing.com/howto/b18cswap/swap.html
The Internet is your friend.