dubcac

Check to make sure the solenoids click. You can do this by shutting off the bottle, and clearing the lines of N20. Then turn the car to the on position, arm the nitrous switch, and step on the gas. You should hear them click when you reach WOT. If they work, your bottle pressure was probably too low. Optimum pressure is 900-1050 psi, anything under 900 you won't really feel much. I hope you have a pressure gauge. You should feel a 75 shot.

BonzoAPD

yeah you should definetly feel a 75 shot. something must be wrong. Did you test the lines to make sure they are clear before you tried it?

madlow

thanks guys!

Im getting a zex kit soon and thinking about running a 75 shot to my b18b. After reading through your comments Im going to get a skunk2 intake manifold and crower 404 cams.

Shingoblade-GSR

Crower 404's? Are these going on a daily driver?

Shingo

Chrgsr96

You don't think even on a GSR not an LS?? Hmm.. well definetly low 14's then.

SimplyFast

I got my problem solved! Turns out the people who filled my tank forgot to put a washer back after they filled it. Most of the N2O leaked out. The tank pressure was at 600!! So, I took the tank back to the shop were it was filled and they replaced the washer and re-filled the tank for free. Unfortunately it is raining now, so I'll have to wait a few hours to test it all out ... again!

JEFFOS69

Heat the bottle untill the press is at least at 900 - to get a good pull.

BonzoAPD

that explains it. tell us how it goes when you test it

SimplyFast

Well... the test didn't go so good! I got the pressure just right on the bottle but I still didn't get anything. I am going to rewire the whole thing and go form there. Too bad I am going out of town this weekend. I'll let you all know when I get back and try it again!

BonzoAPD

thank sucks bro