I got a check engine light on in my car. I ran into some problems when i stopped in a water puddle at the bottom of a driveway and drove off. My intake seemed to pick up a little bit of water. It sounded all garggled and messed up but now it seems back to normal. The check engine light is still on though. Nothing seems out of place, not even a wierd smell. What do you think i should do?

 

did you find out what kind of code the cel is giving you?

 

take off your manifold you might still have water in there

 

this isn't good....

 

yea, i dunno, it just started doin it again tonight, but then it goes away, i have no idea how to take off my manifold, and i gotta work tomorrow at 7 in the morning... how long does that process take?

 

if u dont know what ur doing then dont take off ur manifold. you can however check the cel code in a matter of minutes

 

Do you not have a bypass on the intake?

 

are u sure water went up the intake? what kind of intake do u have?

 

i have an AEM intake and no bypass on it. i didnt think i'd need one... until now. I have no idea how to take off my manifold either.

 

You don't need to take off the intake manifold at this point. :a:
And we're of no use to you without the error code(s).

What you need to do is retrieve the Check Engine Light "code".

This post will tell you how to retrieve them.
https://www.honda-acura.net/forums/s...52&postcount=7

Report back to us with the codes when you have them.
Use this thread to do so.