colin00si

So let me get some votes on what you think is the best exhaust on the market for the Type R....Best meaning Sound,power,style.....price is not a factor....Thanks guys... :lol:

Trey

I think 2 of your best options for sound and power are the SMSP and Hytech custom exhausts. Both are a little exspensive. SMSP is true 2.5" though.

ALso the Buddy Club SPec exhausts are sweet and light but ear bleeding loud.

I personally want the quietest exhaust possible.

NemesisITR

Installed cutom catback and gained 8hp to wheels. Also took off top of airbox.

colin00si

Thanks for the info guys....Trey, toss me a plug for the buddy club website....or somwhere where I can check it out..

bbasso

I like the buddy club3 but yet to hear it in person

Austin

Well...you asked for it, here is my review:

John at HyTech sent me my header back and my exhaust...and I must say that the quality of the product is second to none, but the pictures will verify that to you.


Full Size http://www.imagestation.com/picture/...f.jpg.orig.jpg


Full Size http://www.imagestation.com/picture/...2.jpg.orig.jpg


Full Size http://www.imagestation.com/picture/...c.jpg.orig.jpg

Sits a little lower than I would prefer, going to correct that with installing smaller rubber hangers when I have a chance, and yes that is the incorrect Type-R sticker on the back of the car .


Full Size http://www.imagestation.com/picture/...1.jpg.orig.jpg

Header Ground Clearance


Full Size http://www.imagestation.com/picture/...9.jpg.orig.jpg


Full Size http://www.imagestation.com/picture/...a.jpg.orig.jpg

Exhaust Ground Clearance


Full Size http://www.imagestation.com/picture/...9.jpg.orig.jpg


Full Size http://www.imagestation.com/picture/...e.jpg.orig.jpg

Dyno Testing

Car facts -
Comptech icebox and intake
Mugen headgasket(no correction to cam gears, roughly at -1.5, -1.5)
Hondata intake manifold gasket, street setup

Run#33 - Testing was done as delivered...just hoping on the dyno and seeing what the car put out.

Run#35 - Just bolted on the HyTech header and HyTech exhaust, test pipe was used.


Full Size: http://www.imagestation.com/picture/...c.jpg.orig.jpg

Run#48 - tuned Hondata and cam gears, realized that the injectors were at 101% duty cycle after 1 run with the hondata, added an FPR to increase fuel, currently at ~60psi, hose on under full throttle(thanks to Michael Yun).


Full Size http://www.imagestation.com/picture/...0.jpg.orig.jpg


And the 2 things that made my day...

1. HyTech header with 18" extension(test pipe) vs HyTech with full exhaust, simply removed the b-pipe.


Full Size http://www.imagestation.com/picture/...0.jpg.orig.jpg

2. My old setup vs current...old setup had Toda B's, Toda valve springs, PowerFC, RC 440's, HyTech header, carsound cat, Comptech exhaust, Comptech icebox and intake


Full Size http://www.imagestation.com/picture/...a.jpg.orig.jpg


Summation...damn this car is fast, it pulls very hard all the way to redline, 1-2 and 2-3 shifts are accompanied with wheel spin with the Azenis...sound wise the exhaust is by far one of the quietest that I have heard...it is on similar to the Mugen, but deeper, hopefully I can get Bob aka Bob#455 on Honda-Tech to take some video of the exhaust so that I can post up what it sounds like.

The car was able to run a 13.8 1/4 mile with a burnt clutch, consistant 13.9 with a 2.2 60ft time...enough for me to win the NHRA bracket 1 races at Sears Point September 8th.

I would like to thank John at HyTech for finally shipping me the exhaust , and I would like to thank Lawrence and Dick at DynoSpot Racing for allowing me to use their facilities at a very discounted rate for this comparison, and Lawrence...thanks for the awesome tune, damn this is a fun car to drive again =), Mike Marsey(Rboosted) thanks for the help with the installation.

colin00si

Thanks for the input....

T-R00

What would be the best performance exhaust for a turbo and what kind of turbo would best work for my 00 itr? I was thinking about getting a revhard stage 3 turbo...

Austin

Thermal Research and Development...3"

And if you want to get a turbo get a Drag3 from importparts.com, the best prices that I have seen, and pretty good customer service.

Austin

pUrExTc

I like the Mugen Sports Exhaust, because it's fairly quiet, and it's made for the Type-R...not running any type of Forced Induction in mind.