quick simple question
Apr 27, 2003 | 07:42 PM
Thread Starter
Joined: Mar 2003
Posts: 114
Likes: 0
From: St Louis
quick simple question
i have a 96 LS with
Apr 27, 2003 | 07:44 PM
Joined: Jun 2002
Posts: 205
Likes: 0
From: San Diego(poway-scripps)
4-2-1 is better low end and mid and 4-1 is mid to top both are real close anyways
Apr 27, 2003 | 07:46 PM
Thread Starter
Joined: Mar 2003
Posts: 114
Likes: 0
From: St Louis
what do you mean by low end mid end and high end
Apr 27, 2003 | 07:54 PM
Joined: Jun 2002
Posts: 205
Likes: 0
From: San Diego(poway-scripps)
low end lower rmp's
Apr 27, 2003 | 07:57 PM
Thread Starter
Joined: Mar 2003
Posts: 114
Likes: 0
From: St Louis
ok and how much hp do you think a 4-1 would give me
Apr 27, 2003 | 08:01 PM
Joined: Jun 2002
Posts: 205
Likes: 0
From: San Diego(poway-scripps)
that would depend on whats done so far and what type you get
Apr 27, 2003 | 08:04 PM
Thread Starter
Joined: Mar 2003
Posts: 114
Likes: 0
From: St Louis
i have a greddy catback exhaust and aem cold air intake with a non vtec motor if i buy them id get the dc ss ceramic coated
Apr 27, 2003 | 08:17 PM
Joined: Jun 2002
Posts: 205
Likes: 0
From: San Diego(poway-scripps)
yeah just depends i would get the 4-2-1 unless you are going to build the head later to rev higher and chipp'd the ecu to rev a little higher
Apr 27, 2003 | 08:22 PM
Thread Starter
Joined: Mar 2003
Posts: 114
Likes: 0
From: St Louis
Apr 27, 2003 | 08:26 PM
Joined: Jun 2002
Posts: 205
Likes: 0
From: San Diego(poway-scripps)
quick simple question
