seth90dx

Yea, can you put a B16A or B18C1 head on a jap spec ZC motor? The ZC is dohc vtec, so how close are the heads?

p'sH23Acoord

Are you sure the ZC is vtec? I don;t think it is. Why would you want to put a b16A head on a ZC?

dubcac

NO

seth90dx

yer right, the zc isnt vtec... Thought it was :dunno: But why couldnt you put a B16A or gsr head on it? They are both dohc, is the bolt patern diff or somn dubb?

seth90dx

Also, can you guys give me (to your best knowledge) all the performance parts available for the ZC motor? thanks.

seth90dx

Another question, does the ZC mate with any D series trany?

p'sH23Acoord

Yes the ZC does mate with the D-series but you have to switch the clutch. I had a crx with an Si tranny. Rocket! 70 mph in second gear at 7000 rpm.

seth90dx

Sounds good to me! Whats up with that clutch? And who makes cams for it?

p'sH23Acoord

The output shaft on the ZC is different then the SOHC output shaft. You need an ZC clutch or Si. As for cams ????

seth90dx

So what transmition did you use to hit 70MPH in second? was that the A6 or Y8 trany? I can use an SI clutch? off a B16A or a D16A6? I know they make cams for these cars I met a guy who had them.... Might have been web cams... I think.

I currently have a D16A6 with an act clutch so if its the D16A6 SI you speak of Im stoked!!! ZC + SI trany + act clutch