question......
Thread Starter
Junior Member
Joined: Jun 2006
Posts: 91
Likes: 0
From: Cedar City, Utah
question......
well, i was wondering if their is any difference between the vtec sohc wiring harness and the dohc wiring harness? and is their any difference with the axles? reason for asking is because my motor in my integra is going, and wanting to rebuild it. but its also my daily driven car. and i cant have it down and not running for too long. so i was planning to put a jdm d15b vtec motor in it for now until i get my motor rebuilt. i found me a motor with everything, but the axles and wiring harness. this is just a temperary set-up.
thanks
thanks
Last edited by JDM_199; Oct 29, 2006 at 09:47 PM.
Apathy Kills
Joined: Nov 2002
Posts: 60,714
Likes: 0
From: The Left Lane
Moved to Engine Swaps.
__________________
:: :ToDspin: - supermod - but who gives a shit?
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
Apathy Kills
Joined: Nov 2002
Posts: 60,714
Likes: 0
From: The Left Lane
Without having the wiring diagrams right in front of me, there is no way to know for sure. :a:
The odds that the swap will plug-n-play are highly remote.
And if by chance it does work, you're stuck with a D-series.
Given the odds and the amount of money involved, IMO you'd be better off to find a POS beater to drive while you rebuild your GSR.
The odds that the swap will plug-n-play are highly remote.
And if by chance it does work, you're stuck with a D-series.
Given the odds and the amount of money involved, IMO you'd be better off to find a POS beater to drive while you rebuild your GSR.
__________________
:: :ToDspin: - supermod - but who gives a shit?
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!