arp headstuds help
#1
Member
Thread Starter
Join Date: Jun 2005
Location: chicago,IL
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
arp headstuds help
I just bought some new ARP headstuds but realized they were the ones for a b18c1 or b18c5 motor. My motor is a jdm b16a. The ones i got are 11mm and bigger than my oem b16 ones, I was wondering will this cause a problem, the guy i got them from said he used the same headstuds before on b16 motors all the time.... Any help would benefit me, jus wanna make sure when i go put them in, that i dont have a problem
#2
Monkey See, Monkey Do!
Join Date: Jun 2006
Location: N. Las Vegas, NV
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
i honestly wouldnt take the chance if i were you.. i mean.. they might fit, but you never know if itll cause clearance issues or anything else for that matter.. exchange them for the ones made for your head..
#6
Member
Thread Starter
Join Date: Jun 2005
Location: chicago,IL
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
thats what i said that they are different part numbers, but was wondering was there anyone out there who had the same arp headstuds(208-4303) i got that used them on a b16 motor cuz the shop only has these in stock and i wanna get my motor going, need help pronto....
#7
Still here... sorta...
Ok... so... getting your motor going with the potential of it blowing a head gasket and setting you back quite a bit is worth you putting incorrect head studs on just because a shop will have to order the right ones? Dude... did you think about that before you asked? Just take them back and get the right ones... :uhhok:
Thread
Thread Starter
Forum
Replies
Last Post
newgsrdriver
Parts Classifieds
4
09-08-2004 12:26 PM