P28 chipped ecu
Thread Starter
Banded
Joined: Feb 2006
Posts: 1,899
Likes: 0
From: Cali-For-Ni-A
P28 chipped ecu
I am going to run a p28 with my b16 motor. The ecu is chipped, vtec 5500, and redline at 9000, i don't know what else... I am just wondering of how good a p28 ecu is...??
On permanent hiatus
Joined: Jul 2004
Posts: 9,716
Likes: 0
From: A forum with actual tech
They seem to be the choice for vtec ecus because they are cheap and get the job done.
It will be fine for your application except for the fact that it doesn't have knock sensor support, so you want to always put 91 or higher octane in and make sure the ignition timing is to spec (16* +/- 2* BTDC at 750 rpm).
It will be fine for your application except for the fact that it doesn't have knock sensor support, so you want to always put 91 or higher octane in and make sure the ignition timing is to spec (16* +/- 2* BTDC at 750 rpm).