Notices
Engine Swaps, Tech & Tuning Swaps, N/A Performance, Forced Induction, Engine Management, & Troubleshooting

Throttle Position Sensor

Thread Tools
 
Old May 4, 2006 | 05:01 PM
  #1  
jay169's Avatar
jay169
Thread Starter
Junior Member
 
Joined: Sep 2005
Posts: 14
Likes: 0
Default Throttle Position Sensor

Does anyone know where the throttle position sensor is located in a 98 Civic HX manual? Also, what are the symptoms when either thats bad or there is a leak in a vacuum hose? i described my symptoms to someone, and thats what they came up with.

Thanks guys.
Reply
Old May 5, 2006 | 06:14 AM
  #2  
teg92's Avatar
teg92
WHAT OK YEAH!
 
Joined: Sep 2003
Posts: 5,565
Likes: 0
From: overthere
Default

it should be on the throttle body along with the map sensor
Reply
Old May 5, 2006 | 10:45 AM
  #3  
96tegls2dr's Avatar
96tegls2dr
Member
 
Joined: May 2006
Posts: 54
Likes: 0
Default

yes it is on the throttle boby. you can acutally test to see if its working by unplugging it. this will put the ecu into limp mode and it will run off of the ecu preprogrammed values instead of the sensors. this also sets the CEL. so if you unplug it and the problem goes away you know that is the culprit. if it doesnt stop the symptom reset the ecu by unplugging the battery for about 15minutes to get rid of the CEL and move on to your next diagnosis. if it is a vaccum line you can spray the vaccum lines with carb cleaner while theengine is running and if the rpms increase the area that you just sprayed is the leak.

does the car idle correctly or is it just doing it under load???? if it idles wrong or jumpy then it most likely is a vaccum leak
Reply




All times are GMT -8. The time now is 09:02 AM.