Skunk2 manifold inlet size?
Thread Starter
Senior Member
Joined: Jun 2002
Posts: 109
Likes: 0
From: Kentucky
Skunk2 manifold inlet size?
Anyone know the diameter of the inlet on the Skunk2 intake manifold (the part that mates with the throttle body) for the 94-01 GSR? Just wondering if a 62mm throttle body would be overkill or if I should stick with something smaller.
Senior Member
Joined: Jun 2002
Posts: 229
Likes: 0
From: albuquerque, new mexico
they make lager throttle bodies...62mm isnt that big..i think the stock tb on an ITR and CTR is like 64mm...and spoon makes one thats 70mm..BIGGER IS BETTER the more air you can get in there...the better it is cause you ultimately controll the position of the trottle...make sense..??
Moderator
Joined: Jun 2001
Posts: 11,776
Likes: 0
Originally posted by taylormadem5
they make lager throttle bodies...62mm isnt that big..i think the stock tb on an ITR and CTR is like 64mm...and spoon makes one thats 70mm..BIGGER IS BETTER the more air you can get in there...the better it is cause you ultimately controll the position of the trottle...make sense..??
they make lager throttle bodies...62mm isnt that big..i think the stock tb on an ITR and CTR is like 64mm...and spoon makes one thats 70mm..BIGGER IS BETTER the more air you can get in there...the better it is cause you ultimately controll the position of the trottle...make sense..??
Just as with exhaust, bigger is not always better. There's a proper size for every application. Intake air velocity is a large factor in the performance of your engine.
62mm will by no means be overkill, that would be my recommended starting point. I'd need to know more about your application and goals before recommending anything else.
Thread
Thread Starter
Forum
Replies
Last Post
jdm style ef
Parts Classifieds
19
May 28, 2007 03:23 PM
chimchim
Engine Swaps, Tech & Tuning
2
Dec 26, 2003 08:18 PM
SanjayR
Integra & 97-01 Integra Type-R
0
Dec 7, 2002 07:44 PM