Hey was up. I am putting a b16a into a 90 civic si. I have the motor in and using the si harness. Only thing missing is the distributor. I have a obd-2 GSR distributor. I heard you can use this How do I wire it up. I have both halves to the clip so what do I do? I did a little reading and I am guessing I can use a jumper harness and go obd-1 and run a p-28 and use this distributor but I dont know how to make it obd-1. Someone help?

 

I would just buy the correct distributor. You can find them on eBay for around $150 new, and a lot less used. I had one that I just gave away to a friend or I would sell you that one.

 

i agree just buy the right distributor and save yourself the headache of doing all the wiring