b16 ring markings
#1
Registered User
Thread Starter
Join Date: Dec 2004
Location: Western Michigan University
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
b16 ring markings
I just got some new piston rings for my b16a motor from JE Pistons. The top combustion ring and the second combustion ring have a little "N" etched in them. Does this designate a "this side up" marking or is that just a manufacturer's tool mark? what exactly is that "n" for?
thanks
thanks
#2
On permanent hiatus
Join Date: Jul 2004
Location: A forum with actual tech
Posts: 9,716
Likes: 0
Received 0 Likes
on
0 Posts
I know that the manufacturing marking has to do with the orientation but I am unsure as to which side it faces. I will check my service manual when I get home because I think that there is also a notching that designates which side faces up.
#3
On permanent hiatus
Join Date: Jul 2004
Location: A forum with actual tech
Posts: 9,716
Likes: 0
Received 0 Likes
on
0 Posts
OK. Just checked it. Manufacturing marks face upwards. There is also a chamfer on both the top and second ring. The top ring chamfer faces toward the piston and the second ring chamfer faces toward the cylinder walls. Hope this helps.