whered you get that mount up for teh 4points? how much was it? do you even remember? thanks alot

 

Are you talking about my rear upper strut bar? It is a JDM Tanabe one that I got of Ebay. I picked it up from www.jarcoinc.com .

 

they look good, but so i hear thats bad to hook them(harnesses) like that..i also have heard as long as they are level not to low ur good

 

When I got seats for my accord I also bought a bracket for my car from wedge engineering. The bracket fit fine but it didn't bolt up at all to the standard sliders that came with the seat, so we had to fabricate some pieces to bolt the sliders to the bracket.

 

BTLFED


what type of harneeses?

 

They are 3" Sabelt 5 point cam lock harnesses. FIA approved.

 

and how they hooked up to the strut bar? locked on? or did u feed the bar there the harness? its hard to see in the pic

 

The strut bar is fed through the harnesses. You can see it better in this pic:


NOTE: I would not do this with just any old cheap ass strut bar, or if you do get into an accident it will probably rip the strut bar off the mounts. The reason I did it is because of how the strut bar attaches and it goes straight across. Their is minimal welding on my bar to come apart incase of an accident.

 

yea i have a skunk 2.... should be fine?

why does the right one look diff then the left attachment?

 

Because the right one is not done correctly. When I got them they sent me 2 long top straps and 2 short, so the short ones don't reach back to the bar. I have to order 2 new ones.h: