Does anyone know where to get a 1 Layer B-Series Headgasket, I want to up my compression ratio, and I want to get my head shaved to .010, instead of
.020.

How much do they run. Also if anyone has a DIY on replacing the head gasket I would appreciate it.

 

Bump!

 

A DIY for head gasket replacement can be found in any shop manual

Since you have done a B16A1 swap, get a shop manual for a car that came with that motor stock, this should supplement a manual for your CRX.

As for the 1-layer head gasket, idk. What I would do is call around to some specialty shops in your area and see who knows what you're talking about, then go from there.

BTW, I like the dark look to your CRX. It's kinda the direction I'm going with mine eventually.

Good luck!

 

Spoon is the only one layer gasket I can think of at the moment.

 

makes sure you clean the old gasket off entirely from the top of the block!!! The make a special remover that works real good! you can get it at AutoZone.

 

I found the 2 layer SPOON headgasket, but I cant find a single layer one.

 

Where can I get one?

 

i'd stick with a 3 layer... but thats just me