JDM D15B Vtec Swap in 88CRX HF
#1
Junior Member
Thread Starter
Join Date: Nov 2003
Location: zxcv
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
JDM D15B Vtec Swap in 88CRX HF
I have an 88 CRX HF. I am putting in a JDMD15B Vtec engine. I want to use my existing wiring harness and ECU. The plugs on the Vtec are different than the stock wiring harness. Does anyone know of a kit or web site or if someone sells a kit to wire up the stock wiring harness to the plugs on the JDM 15vtec?
#2
Z20 H8R
Join Date: Sep 2002
Location: norman oklahoma
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
http://www.hasport.com/Products/ECUS.htm
this is where i got my b16 harness. they might have what you want.
this is where i got my b16 harness. they might have what you want.
#3
most of the clips fit if you are saying obd0. I have done that swap in a hacthback. If you need help or parys let me know. It all depends on if you are gonna stay obd0 or convert or obd1
#4
Senior Member
Join Date: Sep 2002
Location: Colorado Springs
Posts: 548
Likes: 0
Received 0 Likes
on
0 Posts
if you are staying OBD0, you don't want to use your HF ECU - get a Si PM6 or 88-89 integra PG7 - you must use your HF harness and either add the wires for VTEC and knock sensor or get the EFSI-VTEC sub-harness from Hasport ($75) - if you want to switch to OBD1 using the P28 ECU, you need to convert like this: http://www.geocities.com/kurtsi_on/page8.html