I was looking at my amp today and just realized it had these settings on it:





I am running 2 JL 10w1's wired stereo. When I moved the switch to 4ohm and the other one to stereo the subs didn't work. What should it be set at? Should I leave it how it is?

 

connect both your subs in parallell for 2 ohms. then run it in a bridged mode.

 

How do I do that?

 

pull both subs out, connect a speaker wire to the - and + terminal of the sub then to the amp. connect another wire from the first sub to the second subwoofer.