Putting rears in my hatch.
#1
Baddest mf'er...ever.
Thread Starter
Join Date: Jun 2002
Location: Napa, CA
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
Putting rears in my hatch.
Well I just bought a set of JL Audio XR components (can't wait ) so I would like to put my current coaxials in the rear.
I have a 93 CX hatch, and it does not have speaker slots in the back.
What is the best way to install them? A drill and or/dremel? Or should I just get the speaker panels off another model and slap them in?
I have a 93 CX hatch, and it does not have speaker slots in the back.
What is the best way to install them? A drill and or/dremel? Or should I just get the speaker panels off another model and slap them in?
#2
Older Honda Fanatic
Join Date: Jul 2002
Location: Adirondacks of NY
Posts: 3,154
Likes: 0
Received 0 Likes
on
0 Posts
swap the speaker panels... Im not too familiar with the hatch's... but its gonna be more pleasing to the eye to have the stock speaker panels, rather than cutting holes and using the speakers grilles.
#4
some things are just better off left alone. haha jk well in seth90dx's case, if it was my ride, i'd fabricate it. Cut the backing out and make it look good. you could always get one of those sealed enclosure but that's kinda ghetto
#5
Baddest mf'er...ever.
Thread Starter
Join Date: Jun 2002
Location: Napa, CA
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
Yeah there is a Honda junkyard near where I live. (it's an f'ing goldmine!!!) I'm just going to try to swap in the rear panels from the Si or EX. I'll keep you posted.
#6
Senior Member
Join Date: Aug 2002
Location: california
Posts: 558
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by LjN_728
some things are just better off left alone. haha jk well in seth90dx's case, if it was my ride, i'd fabricate it. Cut the backing out and make it look good. you could always get one of those sealed enclosure but that's kinda ghetto
some things are just better off left alone. haha jk well in seth90dx's case, if it was my ride, i'd fabricate it. Cut the backing out and make it look good. you could always get one of those sealed enclosure but that's kinda ghetto
Thread
Thread Starter
Forum
Replies
Last Post
newgsrdriver
Parts Classifieds
1
12-12-2002 01:33 PM