I have a 2 way remote start alarm system in my 94 Teg LS and I can't seem to get the remote starter to work right. The remote start works but it wont stop cranking the starter? The engine would start and I hear a loud buzzing noise about 3 times and the engine shuts off. I connected the tach wire to the tachometer tester plug (blue wire) and I also tried conecting it to the blue wire at the distributer, but still no luck. Can somstileone please help me figure this out.

 

you have to reprogram tach, what remotestart do you have?

if its a dei remote start, just hold the valet button down and start the car and let your tach level out and let go of the valet button and now it's programmed.

 

I have a that I got from Ebay.

Whats a dei? I'll try to do the programing thing, but did I connect the right wire? The single blue wire with a rubber cap on it.

 

That's an eBay alarm for ya.

Ya, just looked at it. Thats one big hunk of crap. Sorry man.

 

kinda off subject, but where did u purchase ur gasket kit from?

 

^^^Who???

 

Not much help here guys.... going way off topic. Anyone got this alarm system to work or have any idea why it's doing what it's doing?

 

like i said earlier its set to tach mode and you haven't programmed tach. it'll keep on cranking since it doesn't have a reference rpm for the remote start to stop trying to start the car. or you can try setting it to voltage sense. i'm not familar to that brand so i don't know what the programming options are to it. check your install manual, or go to where it was installed. i couldn't find their website either.

 

I installed it myself.... and the manual is lost = / I can't even find one online either... this blows, I might have to just buy a new alarm.

 

It's an ebay alarm, they don't have a website. You bought a junk alarm, there is no two ways about it.
Step 1: Remove eBay alarm.
Step 2: Go to your nearest electronics retailer.
Step 3: Buy and have installed a decent alarm.