Notices
Audio, Security, & Automotive Lighting Troubleshoot wiring problems and get equipment suggestions all in one place. Now expanded to include Automotive Lighting

How to remove speakers

Old Dec 13, 2003 | 07:51 PM
  #1  
axhammer's Avatar
axhammer
Thread Starter
Canadian Icelander
 
Joined: Jun 2003
Posts: 103
Likes: 0
From: Toronto, Ontario
Default How to remove speakers

Any can help me, tell me how can i take my rear speakers out. I gotta 95 3 door integ. The speaker don't seem to come out like the front ones.
Reply
Old Dec 13, 2003 | 08:50 PM
  #2  
Shore 96 Teg's Avatar
Shore 96 Teg
I miss my 93 VTEC Lude :(
 
Joined: Sep 2003
Posts: 531
Likes: 0
From: South Jersey
Default

its a bitch....just take out the screws and work it out. Took me like 15 minutes to get them both out. Its even harder to put them back in. good luck
Reply
Old Dec 13, 2003 | 08:51 PM
  #3  
Shore 96 Teg's Avatar
Shore 96 Teg
I miss my 93 VTEC Lude :(
 
Joined: Sep 2003
Posts: 531
Likes: 0
From: South Jersey
Default

now if u wanna make it easier and you can figure out how to remove the entire panel back there....make sure you let me know :naughty:
Reply
Old Dec 14, 2003 | 11:41 PM
  #4  
axhammer's Avatar
axhammer
Thread Starter
Canadian Icelander
 
Joined: Jun 2003
Posts: 103
Likes: 0
From: Toronto, Ontario
Default

F*cK! I play the shit out of my speakers and i blew them, now they are farting, so i wanted to get them out. It's easier to remove the hole panel, but the f&*kin platic tabs, and screws break and mess sh&t up.:madfawk:
Reply
Old Dec 14, 2003 | 11:51 PM
  #5  
Shore 96 Teg's Avatar
Shore 96 Teg
I miss my 93 VTEC Lude :(
 
Joined: Sep 2003
Posts: 531
Likes: 0
From: South Jersey
Default

trust me...you can get them out withough removing the whole panel. when you install new speakers make sure you put base blockers on them (unless you dont have subs) so they wont blow again. its next to impossible to blow a speaker that isnt playing any bass
Reply
Old Dec 15, 2003 | 10:19 AM
  #6  
Meguel24's Avatar
Meguel24
Platinum Plus Member
 
Joined: Jul 2002
Posts: 745
Likes: 0
From: First in line
Default

just use a flat head screw driver to push back some of the plastic to get the speaker out and then also, while you pull it turn in (like a steering wheel) and it will roll out. you might bend some plastic but it okay, no damage happens.
Reply
Old Dec 15, 2003 | 05:22 PM
  #7  
axhammer's Avatar
axhammer
Thread Starter
Canadian Icelander
 
Joined: Jun 2003
Posts: 103
Likes: 0
From: Toronto, Ontario
Default

thanks for helping, i got my F**kin new speakers in. I played the thing and it came out. My new speakers, I can't blow them, my deck is 50watts a channel, these are 160 so i'll be fine.
Reply



All times are GMT -8. The time now is 08:02 AM.