Ok...posted this on the DIY forum...but thought I might get more response here.

I got a strut bar...it's pretty and shiney...I wanna put it on my car! So do I just pop the hood, take the nuts off the strut with my torque wrench, put the bar on, torque the nuts back down, and rinse lather repeat for the other side? Or is there by chance more to it? Any help is appreciated!

 

You said it do as you say

Accordhybrid

 

Thank you oh great senior member!

 

depending on the brand of bar, you might have to jack up one side of the car to get everything to line up.

 

*lol* I figure that hey...might as well torque it down to the same specs as it was put on! And I'm lovin the star wars icon Eklypse.

 

You may have to loosen the bracket bolt for the EGR cable and move it over. I had a problem with it hitting the strut bar bracket.

 

i had to relocate some wires and plugs (cut a couple zip ties and pushed down h: ). pretty straightforward tho

 

i had to remove my factory braces, put the strut bar on, reatt factory, & then tighten it all down

:dunno:

each generation is a little different