Does anyone know (no smart asses please) how to shrink this pic to fit it into my sig . it keeps saying I need the pic to be 450W x 200H. How the f-- do I do that?
This pic:

 

right-click on pic>>>>>edit.....this will open pic in microsoft paint

on the top row select "image">>>>>attributes......this will tell you it's size

on the top row select "image">>>>stretch & skew....this will allow you to make it smaller in a percentage of it's current size

example: a pic that in "attributes" shows to be 1024W x 768H, if you "strech/skew" it 50% will then be 512w x 384h

you just keep "stretch/skew"ing it till you get it under the 450w x 200h requirements.

btw: if you stretch/skew it by diff % on h/w, you'll distort the pic

hope that helps :wavey:

 

here you go chief

 

nice ride!

 

Nice ride dude. Hey, I just got the same front lip and am wondering if all the holes matched up with the stock ones? I heard the ones on the far right and left do, but the rest might have to be zip-tied on. Any suggestions on how it can be done right and how you did it?

 

Check your PM DownLowAcc

 

Tenks mang

:thumbup:

 

can you see it now?

 

I just installed that lip today. What a bitch to put on it was. Oh well, it looks sweet!

 

I told you. my driver side one sticks out a little more than the pass side cause I think they didnt drill far enough in to make it look even. OH well, still looks allright