Hey,

I'm at this point with my grill... and need some advice before I move on.

First of all here are some pics...









Ok, now I am going to dremel the jagged peices off the bottom, then sand it all with rough, then fine... but what grit do you suggest? Also, do I need to connect it any way in the center for support?.. like the top bar to the bottom one.

After that I am going to prime it with gray, and I bought OEM base coat spray can, and DupliColor clear coat.

How in the world do I go about putting mesh on this thing... I'm going to buy the mesh gutter guard I guess from Home Depot/Lowes etc.

Any thoughts or suggestions?

Thanks,
John

 

Looks great! :thumbup:

 

i know i saw a diy article on how to make the grill stick on clubrsx.com ... i'm looking for it right now ...

just don't forget to spray and clearcoat the grill too. i completely forgot to do that on mine and it looks like crap now.

 

i zip tied the mesh :happysad:

 

:thumbup: me too ... my lower grill is all held on by zip ties.

 

I don't see what I would zip tie it to... I'm way confused on this one... I don't even have an idea of where the mesh would go. Behind the whole thing? In front of where the grill screws into the car?

 

The mesh goes in the middle. I used fishing line to tie mine under where the screws go into. I don't really remember it that well, but if I get some time I'll take some pics if ya want.

 

I'll see if I can't get some pics of where have the mesh held on for "just in case" cuz other wise, mine is basically just wedged in there and it keeps itself in there.

 

Yes please give me pics, even after you two guys' descriptions I am still very confused. I feel stupid here...grrr.

 

i would fill in the hole in the back section of the grill first, then get it real nice and smooth. to attached the mesh, i cut a general shape out and after some trimming I fiberglassed it in place on the back of the grill. epoxy or superglue would work too.