hello, all, i have been looking at the specialty products alignment kits for a 92 accord and was wonderin which ones i should go with. should i go with the sliding/adjustable ball joint kit or should i go with the upright anchor bolt kit. i was just lookin at nopi.com incase i did nto explain it right, but any suggestions would be appreciated

 

SPC makes very good kits

the ball joint will be cheaper to install, but not by much. & the ball joint kits are easier for the alignment guys to adjust

 

but which will be better as far as not rubbing the inner fender when adjusted? i have read of the ingalls kits and some kits rubbin after install

 

thats going to happen no matter what kit you get.
all kits basically move the ball joint/control arm out further to compensate for camber. onc eyou correct abotu 1.25 degrees, you are at risk for fender to control arm contact.

 

i have the specialty products front ball joint kit on my 94 accord, i have the kit adjusted all the way out because im lowered to a one finger gap on 16's. it rubbed a little when i first lowered it so i had to use a dremel and cut out the plastic in the fender. what was weird is that on one side it cleared it by like 1mm, and on the other side it would bang/rub. i had to put my weight on the fender to pop it down into place whenever i would lower it off the jacks. over time it eventually wore a little dent or something in there and it doesn't bang anymore.