i guessed that one i do know a bit but thanks for the imput

 

cleaning it out hepls sometimes. look at this:
http://www.cb7tuner.com/vbb/showthre...&highlight=iac
later.

 

sorry not trying to be a jerk just helping

 

ok i will try that too but my prob is fixed

 

ok my dumbass went ahead and cleaned the iac and now its doin it all over again i should of left it alone but yea there was alot of carbon i used tb cleaner now its clean and my prob is back any ideas???

 

first re do the idle learn again.did you replace the iak gasket you might have a vak leak(to check for a vak leak spray all over the intake with brake clean if the rpm changes while you spray a certain area that would be where your leak is).you got a book rite you could also reset the idle using the air bleed(the air bleed if you don't know is a Little screw on top of the throttle body.you might as well take the throttle body off and clean it out too and replace that gasket go the full show)so unplug you iak while its running and turn the air bleed you will want about 600-800rpm with a hot engine.plug back in the iak and re do the idle learn shit.if that doesn't work your throttle might be out of adjustment their is a little screw on the tb you want about .5 of a volt from the middle wire(keep it all plugged in turn the key on tap into the wire connector with a small safety pin use a volt reader and adjust the screw till you see a good .5 volts).try this if none of it works we will have to re think it.

 

ok sorry its been so long i had to take a break from it it was gettin fustrating
anyway i started all over i rechecked FIT and ajasted slightly i toned down my idel with the ajustment screw it was runnin bout 1000 and 900 so now its steady at 650 after i did the relearn proc so thanx everyone for the help problem solved