hello,

i've recently purchased a honda accord, as a gift from my brother i received aftermarket tyc taillights which i installed with the help from this forum. The installation was actually fun so i decided to replace the headlights with a projector headlight. But i have some problems "again".

First, can anyone imagine what the third projection is for?



Second, can i get the plastic part for the blinker for the wiring.

 

Welcome to HAN and familiarize yourself with the search button.
Read this https://www.honda-acura.net/forums/s...d.php?t=209717

I kinda liked them in the first place just because they are different but then I heard about the horrible output so I changed my mind.

I think the first one from the left on the first pic is the turn signal, middle is the high beam and 3rd is the low beam.
The best way to find out is to try to plug in your bulbs cause the HIGH beam bulb wont fit in the low beam slot.

Be sure to post a DIY and pictures of them installed after you are done.

 

crap thats why i bought them too, i wish i knew that before hand. oh well i'll try it anyways.

 

Well! they could be good, you never know . I am realy interested in how they will look on a car. They may give you a crapy output but will look different fo sure and you can alway cover the output with some foglights.
Quality is my main concern cause I've heard that the Halos burn out very soon in those aftermarket brands.

Goodluck and please put some pictures of them when you are done.

 

well i just tried to check the output for the headlights and it turns out that the molex (the plastic hold for wires) is not a perfect fit. i don't want to strip the stock molex, can i get them any other way?


This bulb doesn't look anything like the stock bulb, anyone know where i can get this type of bulb for stronger output.

 

The bulb you posted in the picture is an H1 Bulb and your stock 9006 wont fit in there. You can buy another H1 bulb to get more light from Pepboys, Autozone, Ebay or a local performance store

What exactly is the Molex? post a picture of it if you can.

 

aftermarket projectors dont usually use the 9005/9006(?) your car comes with... you have to get a new set of connectors.

 

i dont know if you already got the answers you were looking for but............the third projector is definately for the the turn signal light. and the wires on the back are for the halo lights that light around the other two projector lights. the way you want to set them up is............first the some of the insullation from your turn signal wire............then wrap the wires (the ones coming out of the housing that are shown in the picture above) wrap those wires around the turn signal wire where you cut off some of the insullation. then wrap electrical tape around it. what is going to happen is that when you turn on your turn signal light, only your turn signal lights, the halo around the projector lights will light up. and it will have that BMW look to it

 

before i start changing the wiring, does this affect my warranty in any way?

 

Yes it will effect your warranty but just for that part.
I mean lets say you cut and hook up different cables and something goes out because of that, its not a factory defect so you have to pay to get that fixed. Thats pretty much with all the mods cause they are not OEM so Honda wouldnt cover that.
Make sure to disconnect the battery, write down radio frequencies and have the radio code handy before you actualy do this.