I own a '91 Accord and recently replaced my two front rotors. Not sure if yours is similar to mine but I'll give you the step by step process anyway. Remove the caliper and situate it to the side, out of your way, then remove the large center retaining hub nut. You'll need the following tool...Axle Puller w/slide Hammer (pics attached below) to remove the rotor. Having this tool will make your task easier, rent one if you don't own one. Alligned and attached the Axle Puller to two of your wheel studs, using the lug nuts to secure it firmly in place. Make sure they are firmly in place,without any play, otherwise you'll end up breaking a wheel stud or two in the process. When secured, pull the hammer back several times to loosen the grip of the rotor from the bearing housing, until the rotor/hub assembly comes off. Then you have the rotor/ hub assembly as you want it (off the car) on the pics you posted. Just follow the instructions on how to remove the four screws to seperate the rotor from the hub bearing assembly. Reverse to install. Good Luck! :thumbup: :joshers: