I just got my Apexi n1 catback in today and i went to install and i think that the person i bought the car off of redid the exhaust becuase itwas pretty clean all the way up intill were the cat was suppose to be......... Either I am really dumb or the cat is gone and the pipe were the resignator** was extra long to make up for the cat. It kinda looks like a hack job to me... but its all bolted on......... what should i do in order to install my exhuast...... If anyone has pics of what it is suppose to look like it would be greatly appriciated. I have a 92 civic cx hatch.....

 

if its straight pipe with no cat simply bolt it on where the cat would have ended.

also on my car the cat comes right off the header...like you can see it under the hood. don't know about 92s

 

i would bolt on were the cat is suppose to be but i would have a gap......... i dont want to go spend money on a cat, and i dont wanna weld unless i can have one side bolted on cenecting to my catback, and then they other side welded on, i dont wanna do sumthin real expensive just yet......i wanna wait untill after i do my swap.......... i need a quick chip fix.

 

the d15 engine in the cx has the cat right off the exhaust manifold, not underneath. Therefore u really can't buy a catback for a cx. What you can do is find the exhaust of a dx hatch and it should bolt right up. Not sure, but I know that the cat is right off the manifold. Or you could just hack your exhaust where it should mount up and have something fabbed to hook up to your catback those are really your only options.